Methods of measurement for waveguides - Waveguide power holding capabilityWhat is BS EN 61580 8 Waveguide power holding capability about? BS EN 61580 8 is an international standard that provides the methods of measurement for waveguides. BS EN 61580 8 describes the measurement of the power holding of a waveguide using a multiplying loop. In this case, the input power required is much less ( 10 dB to 12 dB) than when the WUT is directly connected to a high power source. Loop power is measured via coupler PS, and reverse

What is BS 3338-4 – Tin and tin alloys about

Information systems acquisition

PAS 77 IT Service Continuity Management

BS EN 62490-2 helps in determining the properties which are useful in performing the measuring method for surface mount capacitors

Raw and vulcanized rubber is any type of rubber that's been hardened through the use of heat and sulfur

A new Clause 7 (Operational management) which is an amalgamation of Clause 7 (Operational control) and Clause 8 (Organizational resource management) from PAS 402: 2009

significant errors in velocity measurement are introduced through waveform distortion and can only be reduced using procedures that are outside the scope of this document

condensation control

particles and gaseous or vapour contaminants

Steel pipes for pipeline transportation systems within the petroleum and natural gas industries are covered by ISO 3183

The reference method and procedure provided by BS 5086-4 assist you in the determination of salt content in butter

What is BS EN IEC 60793‑1‑54 - Optical fibres about