End mill holder Weldon PSK 63 - 32 - 90Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For sealing tools with internal cooling

For safe clamping of taps in end mill holders according to DIN 1835 B

maximum = 50 mm)

For d = 60 only with four fi xation screws according to DIN 912

and are noted for their tailored inner struts

The caliper will be ready for measurements as soon as it is switched on with the LCD screen displaying the actual slider position

Bearing edge ground

- with 2 connectors Ø 6 mm and Ø 8 mm

chip breaking

Angle reading and adjustment using a vernier

Sealing capacity up to 80 bar

Extension rod