C200E-325 Locking AssemblyDouble taper, non self centering design for use in counter bored components. Mounted component remains fixed axially during installation. View Catalog PageInstallation & Removal Instructions

Porous flanged bronze bearing is press-fit in sturdy zinc die cast sphere with felt strip for lubrication

Clamping coupling portion will not mar the shaft

Ideal for wash down applications in wet or harsh environments or where sanitary conditions are a factor

Traditional cost effective rigid coupling design provides torque transmission and alignment

Design fully engages the shaft without marring

Recessed screw head provides safety with an outside surface free of major projections

Provides greater axial holding power than set screw or one-piece clamping collars

Ideal for space constrained areas

self-centering design for use in through-bored components with extremely high torque and/or bending requirements

Extra thick non-conductive rubber liner corrects misalignment up to 2° while reducing noise & vibration

Allows you room to re-bore the ID without damaging the clamp screws

medium taper