Morse taper adaptor SK 50 - 2 - 60Application: For mounting tools with Morse taper shank and tang according to DIN 228 1 form B. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Without the illustrated cutting tools

Accuracy according to DIN 875

For the coolant supply through the centre of PSK toolholders

Measuring contact points are designed to allow measurements near to the bottom of blind holes

- Clamping accuracy at the centre 0

All holders are made of forged steel

T-nuts 18mm

because only the shaft diameters and the squares must fit

Rolled thread

2 x 53 x 18

Tool steel

Coolant pressure up to 100 bar