Machines and plants for the manufacture, treatment and processing of flat glass. Safety requirements - Drilling machines1 Scope 1. 1 This European Standard contains the requirements for stationary machines for the drilling of flat glass, using a powered rotating tool. Stationary machines are classified into: b) manual; b) semi automatic; c) automatic single head or multi head; d) fully automatic.

What is BS EN 61189-2-721 - Relative permittivity and loss tangent about

A colour spectrophotometer has been added as an alternative method to determine colour index in Clauses 1

Section 2: General auditing recommendations

Guidance in PD IEC/TS 62446-3 can help you improve the quality and performance of PV modules by providing inspection requirements on the quality of the PV systems

ISO 11073 series of standards enable communication between medical devices and external computer systems

a 4 mm thick test specimen of PA66 requires more than a year to attain its equilibrium moisture content in standard atmosphere 23/50 (see ISO 291)

carbon blacks

NOTE Additional aspects of environmental impact are addressed in ISO 14971

This document is not applicable to cableway installations for the transportation of goods nor to lifts

This risk assessment can determine that tests and test parameters other than those contained in this document are acceptable

This document specifies the scheme for the assessment and verification of constancy of performance (AVCP) of cements

These products require evaluation to appropriate end-product safety requirements