Plastics moulded parts. Tolerances and acceptance conditions1 Scope This document specifies possible manufacturing tolerances for plastic moulded parts. This document specifies all integral features with general tolerances with surface profile tolerance within a specified datum system. It allows for additional specifications in case of functional needs and requirements using the ISO GPS tools for dimensional and geometrical tolerating. This document addresses injection moulding, injection compression moulding,

BS EN 61158-6-22 specifies the protocol of the IEC fieldbus Application Layer

This European standard for copper alloy ingots

Who is BS 3446-3 - Refractory materials - Applications in the metallurgical industries for

Who is ISO 21143 for

Environmental Product Declarations

but these are controlled by patent rights and not covered by BS EN 16506

BS 6100 (all parts)

This part of IEC 60645 describes methods of test to be used for approval testing and guidance on methods for undertaking routine calibration

Why should you use BS EN 14119 - Action of microfungi on textiles

They resemble the chemical composition and physical properties of cocoa butter very closely

and guides about the protective devices mounted on liquid-immersed power transformers with or without a conservator for indoor or outdoor installation

1 ml/l to 1