Morse taper adaptor BT 50 - 1 - 45Application: For clamping tools with Morse taper shank and thread according to DIN 228 1 form A. Delivery: With built in tightening bolt All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Flute geometry with special design

wrench and collets

For retaining screw DIN 6367

For the storage of collets

Only nominal size d can be clamped (applicable up to 120 bar)

- Honed collet boring

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance3

With bolted corpus

Suitable for internal coolant

For mounting straight-shank tools acc

right angularity: 0

With retaining screw