Petroleum products. Determination of sulfur content. Oxidative microcoulometry method1 Scope This International Standard specifies a method for the determination of the sulfur content by oxidative microcoulometry of petroleum light and middle distillates with a final boiling point not higher than 400 C. It is applicable to materials with sulfur contents in the range of 1 mg kg to 100 mg kg. Products with sulfur contents above 100 mg kg can be analysed after dilution with a suitable sulfur free solvent. Products with sulfur contents

Food industry

What is BS QC 400102 - Fixed low-power non-wire wound resistors used in electronic components about

What is BS 1660-11 – Gauge specification for machine tapers about

With obedience and compliance to BS EN 12441-6

This British Standard specifies requirements for dental wrought precious metal alloy wire as follows:

The punched slot allows the unit packaging to be attached

physical properties and special requirements for tensional steel strapping used for lifting

the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not

General plan

cutting rate and methods of cutting

This International Standard specifies principal density values for colour 16 mm and 35 mm motion-picture prints and slides intended for television transmission

BS 5502-81 is a standard that covers the design and construction of chemical stores