Continuously hot-dip metal coated steel sheet and strip. Tolerances on dimensions and shapeThis European Standard specifies the requirements for the tolerances on the dimensions and shape of continuously hot dip metal coated flat products (strip of all widths and sheet or lengths cut from it) with a thicknesses less than or equal to 3,0 mm of low carbon steels for cold forming and of structural steels. The thickness is the final thickness of the delivered product including the metal coating. This European Standard applies to all hot dip

based on the authors’ experience

Choice of fit

The primary aim of this and other British Standards in this series is the establishment of a size designation system that indicates (in a simple

safety devices

after modifications

BS EN 60976 describes measurements and test procedures to be performed by the MANUFACTURER at the design and construction stage of a medical electron accelerators but does not specify acceptance test to be performed after installation at the purchaser's site

Permissible variations AL0 for length L0 of unloaded spring

Subclause 6

Under BS EN 13975 two different provisions are addressed:

the stages of the assessment “life cycle” to which it applies and this British Standard’s focus on specifically IT aspects

This British Standard

Criteria for the design and the assessment of such equipment are given in an annex of this standard