C.A Technologies Lynx 100CVT Pressure/Siphon Feed Spray GunsLynx 100CVT (Abrasives) The Lynx 100CVT is a standard conventional air spray gun for spraying abrasive materials, porcelains and ceramics. The fluid nozzle orifice and fluid needle tip are fabricated from Tungsten Carbide for maximum tip life. The two piece fluid nozzle makes this a more affordable option. Air Inlet 1 4 NPS (m) Fluid Inlet 3 8 NPS (m) Weight 20 oz. CFM Dependant on Air Cap

Adjustable Pressure

- For unmatched spraying performance in high or recessed areas

Components: Fuel shutoff valve · Heavy-duty industrial air cleaners hold up under extreme conditions · Large low-tone mufflers to reduce noise to lowest level possible · Easy-access and protected control panel with magnetic circuit breakers and GFCI-protected receptacles · Large capacity fuel tank for extended run time

HDS Heater

no matter the part orientation (even upside down)

or a smaller setup where your Big Rig cannot go

1 x 30ft (9m) Super-Flex Air Hose

and value built into every reel

CA-4004-PMAH

1/4 inch Female NPSM swivel at both ends

and utilizes a 50 ft

GEN-14000 Includes: