Tapping chucks for synchronisation 32 - M4-M33 | ER 40Application: For machining centres with synchronous spindle. Note: Synchro tapping chucks compensate synchronisation errors. Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap, which can cause high frictional forces on the thread flanks. A possible increase of axial force during the tapping process is reduced to a minimum. Suitable for internal coolant. Coolant pressure up to

low warpage hardened

Jaws with grip serrations und fine step for workpieces with max

Extension rod >6mm

With built-in tightening bolt All holders are made of forged steel

Calibration of the angular position of spindles of milling-turning centres

accuracy: 0

Application:

The chucking diameter is configured for a tool tolerance of h6

Hinged mounting device for toolholders

U/min: 7000

4 und 5 mm = h4

For horizontal and vertical clamping of round and flat workpieces