Shrink chuck 4,5° SK 50 - 12 - 200Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

5-30mm and 25-50mm range are supplied with setting rings

Standard type without safety clutch

- Instruction manual

Perforated plate for mounting accessories

Hardened steel

and are noted for their tailored inner struts

clamping depth = 61

For measuring the groove diameter of shafts

Stainless steel design

One turning toolholder - four possibilities:

Made of precision ground hardened stainless steel

20 mm only with reduction sleeve)