C170E-393 Locking AssemblySingle taper, self centering design with mounting flange for use in through bored components with smaller pitch outside diameters. Mounted component remains fixed axially during installation. View Catalog PageInstallation & Removal Instructions

Traditional cost effective collar design

Clamping coupling portion will not mar the shaft

-60° to 180° F temperature range

Design fully engages the thread for secure locking

Self-lubricating bearings resist corrosions

Provides greater axial holding power than set screw or one-piece clamping collars

Heavy guage two-piece housing has rust proof plated finish

Extra thick non-conductive rubber liner corrects misalignment up to 2° while reducing noise & vibration

oil resistant rubber liner which corrects up to 2° misalignment while reducing vibration & noise

Bearing insert is encased in non-conductive

Housing is crimped together at bolt holes

Keyless Rigid Coupling with high torque and overhung load capacity