OG9-5 W/Cobalt Brembo CalipersFitting 08 10 Cobalt SS Brembo calipers to your ng9 3 is a great upgrade. But and adaptor kit is needed! THESE BOLTS ARE LONGER THAN THOSE USED ON THE NG9 3. Sold in pairs. This kit included specially machined bolts to adapt from m14 holes in the spindle to the m12 hardware needed for the Cobalt calipers. ALSO! The calipers are not centered over the rotor when using the modified Cobalt rotors. Because of that, a shim in needed between the wheel

The irregular outside profile helps to prevent the sheet metal of the chassis from shearing at the tow of the weld

This helps prevent blown head gaskets

machined to reach the bottom of the mounting lug

Then remove the manifold and inspect the spacer and manifold for any port-matching that may be needed

’ Shims can also help to slow and/or greatly reduce heat transfer from rotor/pad into the calipers and then brake fluid

while not our preferred method

These plates are made to weld in from the underside of the chassis to provide the most support possible

including Z20 and C20 variants

so here is our solution

The kit complete with the hardware needed

This will be added to the site soon

The kit also includes a MAF relocation adaptor making the MAF and filter location versatile and able to be used with T5 and T7 setups