Fiamma Awning Ground Stake Plate KitThis is a Awning Plate Kit for the Fiamma awning legs Ideal for fixing front legs to the ground for F45S and F80S awnings in order to increase the resistance in case of strong winds Made from extra strong plastic The kit consists of 2x ground plates and 8x rock pegs

If your rig is connected to the internet and your Cerbo GX is communicating with Victron's free online monitoring service (VRM)

the cut edges lose their protective coating)

It is applied as a surface coating measuring 30-microns

Weatherproof-suitable for small open-cockpit boats and other harsh environments

Mounts to left side rear door – drilling is required

with the capability to utilize the full 50A for charging and AC loads

The monitor can also be configured to alert you with over or under voltage alarms

this Mabru unit runs directly from your 12 volt DC battery bank

these shims are not needed

Allows the rear doors to open even when bikes are on the rack

For a 159" wheelbase Promaster you will need approximately 3-4 cans of spray adhesive)

Lonseal’s recommended adhesive for vehicle installation on horizontal surfaces such as floor