Metallic tube connections for fluid power and general use - O-ring face seal connectors1 Scope This part of ISO 8434 specifies the general and dimensional requirements for the design and performance of O ring face seal connectors made of steel for tube outside diameters or hose inside diameters of 6 mm through 38 mm, inclusive. These connectors are for use in fluid power and general applications where elastomeric seals can be used to prevent fluid leakage, including leakage caused by variations in assembly procedures. They are intended

use ISO 6401

This part of BS 8204 gives recommendations for the materials

and the activation of the gas supply system of inflatable buoyancy support systems

and in certain circumstances

It does not deal with the formulation of complex and commercial mixtures highly loaded with solids

BS EN 13476-2 specifies the definitions and requirements for pipes

and includes requirements for the following types of fuel-using equipment which are considered to present particular hazards:

This European Technical Report addresses the provision of information for medicinal products in alternative formats suitable for blind and partially sighted people

The method is not applicable if anionic surface active agents are present

precision and test reports which allows you to ensure the structural integrity of petroleum products

Firms that provide biometric equipment and services

and static strength of the additional attachment