General purpose three-phase induction motors having standard dimensions and outputs. Frame numbers 56 to 315 and flange numbers 65 to 7401 Scope This EN 50347 covers general purpose standard dimensioned three phase induction motors for 50 Hz with rated voltages not exceeding 690 V for industrial purposes having dimensions selected from IEC 600721 in the range : Frame numbers shaft heights : 56 mm to 315 mm Flange numbers pitch circle diameter of flange : 65 mm to 740 mm It gives tables of fixing dimensions, shaft extension dimensions and output powers.

This approach is currently used by Spanish grinders in order to control the efficiency of their processes and is effective for granulates with particle sizes the bottom limit of which is more than 0

with or without cast-in-situ concrete for the construction of beam-and-block floor and roof systems

Testing labs for copper tubes

which can arise during operation and maintenance of mechanical handling equipment defined in clauses 3

The conventions used to draft BS EN 61784-3-14 are defined in Clause 5

entered into

BS EN IEC 61290‑4‑4 provides the general background for optical amplifier gain transients and their measurements and indicates those IEC standard test methods for accurate and reliable measurements of the following transient parameters:

BS EN 12193:2007 replaces BS EN 12193:1999 which has been withdrawn

ISO/TS 17728 provides general instructions and specific requirements for obtaining samples and transporting them to the laboratory

This document does not address protection for the forearm due to axial forces caused by an impact on the fingers or fist

trueness and robustness) with specific requirements for qPCR and dPCR

provide physical protection