Petroleum and natural gas industries. Glass-reinforced plastics (GRP) piping - Qualification and manufacture1 Scope This document gives requirements for the qualification and manufacture of GRP piping and fittings in order to enable the purchase of GRP components with known and consistent properties from any source. It is applicable to qualification procedures, preferred dimensions, quality programmes, component marking and documentation. This document is intended to be read in conjunction with ISO 146921.

BS 7024-3 specifies the characteristics of 130 mm (5

shape and mass of hot-rolled taper flange I sections

surface treatment of hexagonal head bolts

floating production vessel hulls

Who is BS 2A 175 for

In the case of composite seals for materials of hardness ranging from 76 IRHD to 95 IRHD the requirements for elongation at break

What is PD CEN/TR 16099 – Summary of water pressures specified in published CEN/TC 192 standards about

position of the centre of gravity

and heavy tights

Using BS EN 61000-4-6 you can specify requirements of electrical and electronic equipment for electromagnetic disturbances coming from intended radiofrequency (RF) transmitters in the frequency range 150 kHz up to 80 MHz

light fastness and the chemical

The property measured by this empirical test procedure depends