Edwards Pipe Die 1" x 4-1/2" 90°Details Edwards PBD90 1X4. 5 Description Fits in the Edwards 10 Ton Bender run off an Edwards Ironworker with the PowerLink System, this die is able to make bends up to 180 in Pipe, our dies produce smooth, even bends. The robust brass follower extends the life of the die. Edwards PBD90 1X4. 5 Includes (1) Pipe Bender Die Edwards PBD90 1X4. 5 Features Designed for bending Pipe (ID) Schedule 40 Precision machined components to ensure the highest

4x Low‐profile round polyurethane contact pads

Single-point safety release

Tailstock may be offset for turning taper

Oversized needle bearing on the drive sides and ball bearings on the non-drive side assure proper shaft alignment and maximum life

This assures positive alignment and centering of the connecting rods and crankshaft in relation to the crankcase

the HSP-200M-C can deliver 200 tons of pressure on the main ram

and ProLTS 19 Airless Sprayer

Connect elbow fitting (1 or 5) to the lower and bushing (2) if needed

Service Parts M16 x 60 GRUBSCREW STST

Graco 17C565 KIT REPAIR CHARGER 120V USA

Roller assists forward movement for easy cleaning

Designed for quick and safe removal and replacement of manhole covers by yourself