Shrink chuck 4,5° HSK 100 - 20 - 105Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For sealing tools with internal cooling

- Warranty card

To increase the specific contact pressure per unit area

Axial sealed with two O-rings

Ratchet handle gear types : 72 teeth

For the coolant supply through the centre of  HSK toolholders

The caliper will be ready for measurements as soon as it is switched on with the LCD screen displaying the actual slider position

Torque range : 20-110 Nm

The tool inserts are made of oil-resistant

such as precision boring bars

vice clamps

Advantage: