Metallic materials. Tensile testing at high strain rates - Elastic-bar-type systems1 Scope This document specifies methods for testing metallic sheet materials to determine the stress strain characteristics at high strain rates. This document covers the use of elastic bar type systems. The strain rate range between 103 and 103 s1 is considered to be the most relevant to vehicle crash events based on experimental and numerical calculations such as the finite element analysis (FEA) work for crashworthiness. In order to evaluate the

BS EN 2713-009 specifies the characteristics of YAG X3 laser printable

Risk retention

The adhesive is set at room temperature or by heating

This method can be used to determine Cr(VI)-mass fractions in solids higher than 1 mg/kg

or “automatically” by using an insertion test signal analyzer

development or further functionality of active infeed applications

It is not applicable to the following:

and partial oxygen pressure)

What is PD CEN/TS 17249-2 – 112 eCall for HGVs about

Lighting fitting manufacturers

and another cable

and limited configurability