End mill holder Weldon BT 40 - 20 - 160Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

In the tailstock of the lathe so that no friction between the workpiece and the tip occurs

E2= 10 pieces

With ball bearing clamping nut All holders are made of forged steel

For the storage of collet chuck

The base is designed with a thermal heat isolation hand grip

Parallels are widely used as a tool for tensioning and positioning

depths and steps

Ratchet stop

Centering nut (Pair)

For use on vises

For holding tapers according to DIN 69871

Excellent concentricity in the system (chuck + collet + clamping nut)