Shrink chuck 4,5° HSK 63 - 04 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Set consist of

Heat-treated steel

5 x 58 x 18

- reading 0

SK 30 without coolant exit bores on the end faceDelivery:

For mounting the coolant tubes in PSK toolholders

Low material loss

Zero setting at any position

DIN 1835 form A+B+E and DIN 6535 form HB+HE

For clamping tools with Morse taper shank and thread according to DIN 228-1 form A

Spannkraft voreinstellbar durch Rillenmarkierung

20 mm only with reduction sleeve)