Hydraulic fluid power. Positive displacement pumps and motors. Determination of derived capacity1 Scope This International Standard specifies the methods of determining the derived capacity of hydraulic fluid power positive displacement pumps and motors under steady state conditions and at defined, continuous shaft rotational frequencies. Units can be tested as a positive displacement pump, with mechanical energy applied to the shaft and hydraulic energy obtained at the outlet fluid connection, or as a motor, with hydraulic energy supplied to

and those within industrial complexes

Test houses for non-contact voltage detectors

as it is not foreseen in combined transport

The method allows the identification and the determination of the total concentration of the water-soluble fraction of this chelating agent

BS EN IEC 60051‑5 also applies to non-interchangeable accessories (as defined in 3

BS EN 60811-408 on long-term stability test for polyethylene and polypropylene is useful for:

floor and/or ceiling

joints are classified in this standard on the basis of the movements and inaccuracies they have to accommodate

static VAR compensators (SVC) and flexible AC transmission systems (FACTS)

and reduced fuel consumption

authentication and integrity validation

The focus of BS EN 14012 is the achievement of ongoing improvement