Hydraulic expansion chuck HSK 100 - 25 - 150Application: For mounting straight shank tools acc. DIN 1835 form A+B+E and DIN 6535 form HA+HB+HE (larger than dia. 20 mm only with reduction sleeve). Note: l1 = max. clamping depth l2 = max. length adjustment range Delivery: Without wrench All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile

wrench and collets

Retaining screw for mounting of face mills arbors

For mounting straight-shank tools in collets

- mobility allows measuring within machines and fixtures

With built-in tightening bolt All holders are made of forged steel

nuts and plain washers

- According to DIN 69895 for HSK-A and HSK-E hollow taper shanks

- Especially suitable fore wire EDM

closable for tools with internal coolant supply

vice clamps

longer tool life

Not applicable with reductions