End mill holder Weldon SK 50 - 10 - 63Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Note: From d = 25 on two clamping screws Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional

For mounting straight-shank tools with lateral flat according to DIN 1835 form B (Weldon)

bei Ø 6 – Ø 32 mm = h234

Matt chrome finish

All tool sizes can be combined

With fi ne adjustment carriage to feed the slider finely

5V AA Batteries * 3 ( Do not use low self-discharge battery )

E1= 28 pieces

Positive clamping due to penetration of the hardened claw tips

For all solid drills with cylindrical shank according to DIN 6595

- Calibration of the angular position of spindles of milling-turning centres

clamping depth = 52

With coolant channels for optimal coolant at the cutting edge