Tapping chucks for synchronisation 32 - M4-M27 | ER 32Application: For machining centres with synchronous spindle. Note: Synchro tapping chucks compensate synchronisation errors. Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap, which can cause high frictional forces on the thread flanks. A possible increase of axial force during the tapping process is reduced to a minimum. Suitable for internal coolant. Coolant pressure up to

- Rustproof

From DCONWS = 25 on two clamping screws

102 x 38 x 15

Dial face dia

Carbide tipped scriber with clamp

Vernier: 5

because only the shaft diameters and the squares must fit

Scale reading by nonius: 3

Longer durability of inserts

Additional screw for DIN 2080 tools included

Zero-setting at any position

- Absolute/incremental measurement