Explosives for civil uses. Detonators and relays - Determination of resistance to cutting damage of leading wires and shock tubes1 Scope This European Standard specifies a method for determining the resistance to failure of the plastic materials used in insulation of leading wires of electric detonators, or the tubing of shock tube non electric detonators, when drawn over a sharp edge under specified loading conditions.

It also gives practical requirements to ensure the right air quality and addresses compressed air and gases

that National and/or local legislation and instructions may apply

This document is also applicable to the processes of induction bending and strain-hardened products

— diagonal (ply rating marked) tyres for agricultural tractors and machines are specified in ISO 4251‑1 and ISO 4251‑2

This document defines individual concepts that together constitute a vocabulary common to different stakeholders with interests in water service provision

where it is reasonable to expect the pump to be compatible with the product

and heat management is critical

Senior executives of other public bodies with a city-wide remit

It is important to recognize that structural integrity is an overall concept comprising models for describing actions

The test method that manufacturers

BS EN 62455 focuses on Internet protocol (IP) and transport stream (TS) based service access

when mixed with water