Large booster pump fittings kitFittings kit for mains powered rotary vane booster pump. These parts enable you connect up 1 2 in hose to the vane pump, contains ball valve, section of 8mm braided hose and O Clips to make up the bypass. Complete with Glycerine filled pressure gauge. These fitting will not arrived assembled and will require a quality sealant when installing.

Retrofit to existing poles:

DI only or RO/DI Filtration

No worry about running out of charge or damage

It can be connected to a 12v leisure battery and partnered with a flow controller for complete control

two male hoselock connectors and thread adapters

The pressure of the incoming feed forces the water down through the media

battery voltage readout

A set of 3 pre-filters to keep your reverse osmosis membranes in top condition

and tested to the best industry standard with a 'crash test'

Dual Inline TDS Meter for Measuring Total Dissolved Solids in Part per Million (PPM)

Please Note: This is a pump alone and does not include the transformer

Lightweight Aluminium T-Bar