Valves for natural gas transportation in pipelines. Performance requirements and tests1 Scope This European Standard applies to all valves (plug, ball, gate and check valves) used in onshore transmission pipelines for transport of natural gas in accordance with EN 1594, but with a differing temperature range according to the following three classes in accordance with EN 682: 1) 10 C to 60 C; 2) 20 C to 60 C; 3) the range stated by the purchaser for special design. This European Standard comprises all valves which are components of the

This International Standard applies to the marking of information only on the filter

The Serial Digital Interface (SDI) container parameters for DCDM AFR Level 2 and AFR Level 4 are given in Table 1

g)       Annex ZA: Relationship between this European standard and the essential requirements of Directive 2014/68/EU (Pressure Equipment Directive) updated

each specifying an 8-bit single-byte coded graphic character set of up to 191 characters

reinforced and prestressed concrete with specific rules for buildings

and also hazards related to devices for mounting attachments to the arm are covered

03 N or 98

Polyester and polyamide -40°C to 100°C

complying with BS EN 16203 can assist you design counterbalanced trucks in order to carry a capacity load at a standard load centre and improve truck safety under limited working conditions

Inspection of the steel products is a very effective aspect of the steel products and manufacturing industries

availability and maintainability) assurance of software and hardware products

In all but the simplest of