Steel forgings. Testing frequency, sampling conditions and test methods for mechanical tests1 Scope This document gives guidelines for the simplification and harmonization of the specifications for mechanical testing of open die and closed die forgings in International Standards and other technical delivery conditions for forgings of steel. This document a) offers various options for 1) the frequency of testing, and 2) sampling conditions, b) introduces a designation system for the options, mentioned under (a), and c) specifies the test

Annex E (informative) Magnetic properties for austenitic stainless steels

whether they are permanent organizations or temporary organizations established in support of a particular election period

although CEN/TS 17249-6 may reference other ‘L’ subcategories to use this document

manual measurement procedure is to be used

and structural properties

This standard also enables the demonstration of compliance against the target test conditions for the case that their combination is not achievable during tests

Replacement of the performance criterion FS with DS according to the generic standard IEC 61000-6-7

Manufacturer of electrical conductors

the torquemeter method or the wind-tunnel/chassis-dynamometer method

What is BS EN 1444 - Guidance for on-site working methods for fibre-cement pipes about

6 Reference tube

Sphere gaps have been used as a simple and reliable method for the measurement of peak voltage in many industrial test facilities