Sequential sampling plans for inspection by attributes1 Scope This International Standard specifies sequential sampling plans and procedures for inspection by attributes of discrete items. The plans are indexed in terms of the producer's risk point and the consumer's risk point. Therefore, they can be used not only for the purposes of acceptance sampling, but for a more general purpose of the verification of simple statistical hypotheses for proportions. The purpose of this International Standard is to

This document specifies requirements and test methods for marketed and delivered automotive liquefied petroleum gas (LPG)

Requirements for the safe operation and use of associated instruments and equipment are contained in other standards

Why should you use BS EN 60155 - Glow-starters for fluorescent lamps

Who is BS EN IEC 62677-1- Heat-shrinkable moulded shapes for

This European Standard is applicable to connectors used:

equipment maintenance

100 ml and 150 ml nominal capacity for medical use in order to ensure compatibility of use with containers for infusion solutions and intravenous equipment

BS EN 1301-2  applies to drawn wires

Standard height shaft support rails for series 3 sleeve type linear ball bearings

BS ISO 15726 also provides a method of designating the electrodeposited coatings

The test method described in BS EN 13581 helps you to compare the loss of mass and visible defects of treated and untreated test cubes from the same batch of concrete

recommended operation of DTEs is included by implication because of the need to communicate with X