Hot rolled taper flange I sections. Tolerances on shape and dimensions1 Scope This European Standard specifies requirements for tolerances on dimensions, shape and mass of hot rolled taper flange I sections. These requirements do not apply to taper flange I sections produced from stainless steel.

This document specifies requirements and test methods for reusable intra-oral mirrors with a coated glass reflecting surface used for dental purposes in the oral cavity

SM promotes the intelligent selection and implementation of standards

Può essere utile anche per chi inizia un progetto per la conformità ad un nuovo standard oppure per applicare norme non formalizzate

BS 1133-15 specifies properties of tensional strapping which will have a bearing on the choice for particular applications such as tensile strength (including joint efficiency)

IEC 60707:1981

Many different designs of knee joint prostheses are used all over the world and ISO 7207 gives a comprehensive description of the most common knee joint prostheses in accordance with this detailed classification system

1 (BioAPI) for the purpose of performing a tenprint capture operation

It does not apply to overlay welding where cracks are intentionally produced (e

outlining responsibilities and competencies for fire risk assessment

This International Standard provides

NOTE: PD 6669 was conceived as a ‘scheme document’ and is expected to be run in combination with current and future versions of PD 6662

All properties are intended to be determined by the appropriate methods referred to in this document and values obtained shall be presented as laid down in ISO 10350‑1