Shrink chuck 4,5° SK 40 - 14 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Matt chrome finish

Bed height H: 0

- 100µ stainless steel mesh filter

PSK = PSK 50

3 µm radial run-out with a 2 µm clamping nut

5 with h4-tolerance and Ø 6 - Ø 32 with h6-tolerance

For mounting straight-shank tools in collet chucks DIN 6499

minimum and diviation

Clamping possible on both sides

B showing the deviation of each block

Adapter / reduction / extension for polygonal hollow shank tapers

Made of precision ground hardened stainless steel