Bottle stopper drill and tap setThis set includes: 5 16 brad point drill bit. 3 8 16 H3 HSS tap handle for threading can also be used with the coffee scoop kit we have coming soon!

Surface Prep: For best results make sure that all surfaces are clean

CC (Craft Coat)

Using a lathe speed of 2400-3000 rpm

allow each coat to dry a minimum of 1 to 2 hours before lightly sanding and applying a recoat

Craft-Coat produces very little odor and dries to the touch in approximately 20 minutes and can be sanded / recoated within 1 to 2 hours

or other similar product finish

Some of what’s currently going into the 10 packs what you actually get will vary depending what’s in our shorts bin

Clean-Up: Clean brushes

Due to the nature of seashells you will find voids inside shells

10mm brad point drill bit

Blanks measure a minimum of 7/8”x5-1/2” long most are closer to 6” long

MJ is not recommended for use on friction polish finishes or raw unfinished woods