PIERCED NESTED LABEL DIE - Gina Marie DesignsTips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this trick! Plate dies and

Largest layer cuts approx 4

Putting it in flush can cause speed bumps on your machines roller and poor cuts in the future

MEASURES 3

Measures 3

Largest measures 4

It's very important to GMD to test all products prior to selling them and unfortunately while manufacturing in the usa that was not an option given to us

Largest layer cuts 4x4

Largest layer measures approx

please do not buy these dies

Please know cost was not the only reason we moved our production to china

Smallest is 1

Prior to shimming a die if needed try to remove the "outer paper" and run the die back through your machine