Equipment for crop protection. Induction hoppers - Test methods1 Scope This part of ISO 21278 specifies the test methods for the verification of the performance limits of induction hoppers, as specified in ISO 21278 2.

NOTE: BS EN IEC 60077‑5 does not cover parallel connection of fuses

BS EN 2048 specifies the dimensions and tolerances of extruded L-section

NOTE Testing on cell level is specified in IEC 62619

ISO 39001 is an international standard that focuses on requirements and guidelines for road traffic management systems

A Clause 3

based on liquid-chromatography (LC) with ultraviolet/visible spectrometry (UV/Vis) detection for the detection and quantitative determination of 22 organic UV filters in use in the EU framework

NOTE: Disposable extinguishers are not intended to be recharged and are therefore outside the scope of this part of BS 5306

When cables are handled according to the standards provided in BS EN 50290-2-21

BS EN 10025‑2  specifies the technical delivery conditions for flat and long products as well as semi-finished products which are meant for further processing to flat and long products of hot rolled nonalloy quality steels in the grades and qualities given in Tables 1 to 5 (chemical composition) and Tables 6 to 8 (mechanical properties) in the usual delivery conditions as given in 6

PD CEN/TS 17021 describes a method for sampling and determining the concentration of gaseous sulphur dioxide (SO2) emissions from stacks

but is principally developed for the gases listed in ISO 13571

NOTE 1 Clauses 1 to 4 are applicable generally and refer to all connector standards