Grooved pins. Full-length taper grooved1 Scope This International Standard specifies the characteristics of full length taper grooved pins made of steel or austenitic stainless steel which have three equally spaced grooves impressed longitudinally on their exterior surface, with nominal diameter, d1, from 1,5 mm to 25 mm inclusive. The displaced material to each side of the grooves forming an expanded diameter, d2, which is larger than the nominal diameter d1 will cause a non positive

The following parameters are covered: pH

It is the fifth part of BS EN 806 "Specifications for installations inside buildings concerning water for human consumption" which consists of five parts:

The EN 1708 series is a European Standard that discusses various requirements of basic weld joint details in steel

It includes new information about operation modes

for assuring proper operation after installation in the required environment

This part of ISO 16017 gives general guidance for the sampling and analysis of volatile organic compounds (VOCs) in air

and light industrial use

ISO/CIE 11664-4 includes two methods for calculating Euclidean distances in this space to represent the perceived magnitude of color differences

ISO 5832-9 assists you with test methods for efficient evaluation of wrought high nitrogen stainless steel for manufacturing high-quality surgical implants

ISO 23121-1 is intended to ensure the functions of the gas supply system

and maintenance

PD ISO/TS 19072‑5 provides the dimensional features and performance requirements on the connector