Exotek Racing 1977 DR10 Aluminum Rear Clamping Hex (2)Exotek 1977 DR10 Aluminum Rear Clamping Hex (2) (EXO1977) This is an optional set of Exotek DR10 Aluminum Rear Clamping Hexes. These precision machined 7075 aluminum hexes were developed for the DR10 and DB10 models, and feature looser steel cross pin tolerance that unlike the stock plastic hexes, allow you to tighten the wheel nuts without binding the bearings. Package includes two hexes and M2 hardware. Features: Aluminum Includes: (1) Clamping Rear

460 Drive Shaft 5mm Wheel Hubs 4 Bolt Pattern Steering Linkage Included Body Mounts Included Wheelie Bar Included

With it's incredible power output and adjustable parameters

Castle Creations mamba 8s esc

0” size and fit any SCT tire already produced

Continuous Current of 6A (Switch Mode BEC)

OTA programmer supports real-time data recording

Available in Black

60:1 Drive: 2WD Required to Complete:

It works with the following HobbyWing products:

Fits wire diameter up to 13-8ga

​Product Description:

for Cyclic and Tail use