Combi shell mill holder SK 40 - 16 - 100Application: For mounting milling cutters with transverse or longitudinal groove. Delivery: With retaining screw, driving ring and feather key All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Extension rod >6mm

Measuring contact points are designed to allow measurements near to the bottom of blind holes

The internal thread provided in the PSK tool holder for

SK 30 without coolant exit bores on the end faceDelivery:

The fine-adjustment allows the slider to be precisely positioned

ISO 7388-3 - Retention knobs

or fi xation on T-groove tables

The chucking diameter is configured for a tool tolerance of h6

With ball bearing clamping nut

Hydraulic or manual clamping

DCONWS = 6 to 18 with two coolant channels

20 mm only with reduction sleeve)