DR (Mobile) Vacuum De-Gassing Test UnitMobile system for resin vacuum infusion This system has been designed for allowing resin vacuum infusion moulding and composite fibre vacuum forming. The system is composed of: A welded sheet steel autoclave featuring a perfect vacuum seal, equipped with a transparent methacrylate lid that can be manually removed. An oil bath rotating vane pump for high vacuum. A reducer for adjusting the required level of vacuum. A vacuum gauge, for a direct reading

The vacuum connection can be made by means of a G 1/8” male or M5 female double threading connection

they are necessary whenever the working vacuum must be lower than the primary vacuum

pleated polypropylene mesh and AISI 304 stainless steel mesh

allow for a quicker grip

Mini pump sets can also be supplied with single-phase or DC electric motors and they are suited for equipping fixed or mobile working units that require vacuum

- A unidirectional check valve

Servo-controlled 3-way vacuum solenoid valves with bi-stable impulse solenoid pilot valve and with low absorption electric coil

They operate by membrane-piston and exploit the pressure differential between the secondary vacuum and the atmospheric pressure

The multi-stage vacuum generators in this range are suited for interconnecting vacuum cup gripping systems and

not compromising its effectiveness

- Room temperature: from -10 to +80 °C- Installation position: any

fixed to a connecting rod