Can-Am X3 Milwaukee Packout Mount 1.5Can Am X3 Milwaukee Packout Mount is the perfect storage solution. This mount uses existing mounting holes so no drilling is required. Simple remove four bolts and replace them with the supplied hardware. This is a very simple install. We CNC Laser cut our Milwaukee Packout Mount in house from 10 gauge P. O. steel then powder coat it black. You will use some of your old hardware and some new will be supplied. This mount works with the stock snorkels

Mesh pockets on inside & pull bunjee on top (can store shovel blade on bunjee & shovel pole/avalanche probe inside)

Tire sizes 30" and above are upgraded to an 8pr Radial Carcass for improved performance on todays performance UTV's

THIS ISN'T JUST AN UPGRADE

2" X1 Rear Remote EXIT Shocks

Fits side bar or crossbar of roll cage

providing your engine with the air it needs to perform at its best

Turbo System Includes the Following:

We wanted to save you time and give you the confidence of knowing that you installed it correctly

and a location for a second wiper

With these weights you have the ability to bring down cruising RPM but still give you full RPM at shift out without loosing top end speed

When installing make sure you remove your primary limiter which is the grey plastic washer between the spring and the clutch

Measures 16” Tall