20K Potentiometer 7mm ShaftThe 20K Pot Potentiometer is a three terminal variable resistor that is used to vary or change the resistance. It is used to change different parameters in an electronic circuit, such as voltage, current, and so on. The 20K Potentiometer is a passive electronic component that has two end terminals with a resistive element and the sliding contact called the wiper acts as the third terminal. Two other terminals present are used to facilitate stabilized

if the echo cannot be received (the reason exceeds the measured range or the probe does not face the measured object)

Emitter Base Voltage (VEBO) 5V Power Dissipation 400mW Max

as the name implies

This 6 Way DIP SPST Switch is the simplest type of switch in which a single toggle either connects or disconnects a single terminal from other

it features an improved peak current mode PWM control method

with a simple mechanical structure that is simple to assemble and use

5%) Resolution: 1A Frequency 2kHz Operating Temperature 0°C~750°C Buzzer <50Ω Resistance: 20M-2000M(±1

3k ohm 1W and tolerance of ±5%

It's a 3 Pin JST Female to Female Connector - 2mm Pitch

These are Carbon Film Resistor with a value of 1M ohm 1/2W and tolerance of ±5%

Send programme code to the 32-bit STM32 ARM Cortex or 8-bit STM8 microcontrollers with this device

The Raspberry Pi Pico is the first microcontroller board of the Raspberry Pi series